Author Archives: Webmaster

SWMS Safe Work Method Statement for Electrical Conduit Installation Prior to Pouring Concrete

Personal Protective Equipment (tick as appropriate)

Instructions for the implementation of this SWMS: Review the SWMS on site with the relevant employees and contractors. Identify and document the high risk Construction Work to be performed. Identify and document the site PPE requirements for the task. Document any additional work methods, tasks and hazards identified on site and the control measures required… Read More: SWMS Safe Work Method Statement for Electrical Conduit Installation Prior… »

Method Statement for External Water Proofing Membrane for Swimming Pool and Water Tank

Method Statement for installation / application of External Water Proofing Membrane for Swimming Pool and Water Tanks. Ensure Material for water proofing membrane approved prior to fixation. Membrane must be stored in shaded area with ambient temperature of less than 35 º C on wooden pallets neatly covered by a stick fabric and tied securely… Read More: Method Statement for External Water Proofing Membrane for Swimming Pool… »

FCU Installation Method Statement ( Split Units Ducted & DX Type)

Ducted-Split-Units-DX-Installation-method-of-statement

Below document covers FCU installation method statement that covers steps to install FCU units of ducted and DX type air conditioners. By following this HVAC method statement contractor shall ensure that the job execution complies with the project specification and manufacturer requirements and serves the intended function to satisfactory level. Responsibilities for implementation of this… Read More: FCU Installation Method Statement ( Split Units Ducted & DX… »

Fire Hose Reel Testing and Commissioning Method Statement

Below is a precise method statement for fire hose reel testing and commissioning part of project fire fighting system. Automatic wet system is a system that is attached to a water supply capable of supplying the system demand at all fires and that requires no action other than opening a hose valve to provide water… Read More: Fire Hose Reel Testing and Commissioning Method Statement »

Basement MEP Coordination Shop Drawing Preparation and Checklist

Fire-Fighting-Sprinkler-System-method-statement-for-Testing and Commissioning

The purpose of preparing the basement MEP coordination drawings is to prevent the clashing of MEP services during the execution of MEP works at a construction project site. Also to prevent the MEP service form coming below the Minimum clearance required for the cars in the driveway and parking as per the requirements of the… Read More: Basement MEP Coordination Shop Drawing Preparation and Checklist »

Storage Steel Tank Fabrication Construction and Installation Method of Statement

This Method Statement describes the specific safe working methods which will be used to carry out the construction of new storage tank and related facilities. Document covers the scope of work required for the execution of the tank construction works. Below is sequence of activities or steps that shall be followed for the steel storage… Read More: Storage Steel Tank Fabrication Construction and Installation Method of Statement »

Radiation Safety Procedure for Site Gama Ray Radiography for NDT Weld Test

This method of statement describes the specific performance requirement for safe conduct of industrial gamma ray radiography at a project site. The method shall be implemented as per the local regulations concerning Radiation Protection in using sealed Radioactive isotopes in Industrial Radiography. This page gives just general information for basic understanding and should not be… Read More: Radiation Safety Procedure for Site Gama Ray Radiography for NDT… »